| Default Turnout Length | 9.1" (231 mm) | This is the length of the turnout on the QuickSticks. Measured from end tie to end tie. |
|
| Minimum Turnout Length | 7.1" (180 mm) | This is the shortest possible turnout length. Measured from the end PC board tie to end PC board tie. |
|
| Diverging Route Angle | 12.53 (Decimal)
12° / 31' / 48" (D/M/S)
1:4.5 (Ratio) | Decimal - The frog angle in decimal degrees.
D/M/S - The frog angle in Degrees / Minutes / Seconds
Ratio - The frog angle expressed as a ratio. |
|
| Diverging Route Radius | 20" | The minimum radius in a straight turnout. |
|
| Tie Spacing (Prototype) | 20" (508 mm) | The distance between each tie. |
|
| Tie Size (Model) | L - 1.17" (29.7 mm)
W - 0.1" (2.6 mm)
H - 0.08" (2 mm) | The actual size of the tie. |
|
| Tie Size (Prototype) | L - 8.5' (2591 mm)
W - 9" (229 mm)
H - 7" (178 mm) | The original tie size that the model was based on. |
|
| Secondary Frog Angle | NA | The second frog angle for any switch that has two frogs. (Slip switches, 3-ways, dual gauge switches, etc) |
|
| Track Gauge | 0.66" (16.8 mm) | The distance between the stock rails. |
|
| Track Spacing | NA | The center to center distance of the parallel track. (Only applies to double crossovers) |
|
| Substitution Radius | 35" | The approximate radius that a straight turnout can be inserted into. |
|
Fixture Size | L - 10"
W - 6"
H - 0.25" | |
|
| Fixture Weight | 1.441 (Lbs) | |
|
| Fixture Material | 6061 Aluminum | |
My Review 
