• Molded of strong, self-lubricating black delrin
• External cam provides maximum life and travel
• Cam design provides lock on both ends of the throw from 10° above horizontal to the extreme down position
• Direct connection to the turnout through a pin on the slide bar
• Detent to assist in holding the handle horizontal

The throws are internally sprung. Stainless steel springs take up the over-travel and maintains tension to hold the movable points against the stock rails of the turnout. The springs make the machines easy to mount to the turnout.

A shim is provided to raise the stand to tie level and five different end fittings to connect to most turnout are included, including:

• a hook end for ATLAS
• blade for ROCO
• hole for PECO
• Small round pin for Micro Engineering
• round pin for SHINPHARA and others