One of the least expensive manual turnout controls available anywhere, the BullFrog not only offers a low cost manual turnout control solution, but includes all of the same features you come to expect from a turnout control plus more, including:
 | Integrated Control Rod Mount - You have to purchase this separately for other turnout controls |
| Automatic Power Routing - Integrated SPDT switch with the option of adding an additional switch for DPDT operation |
| Very Small Mounting Footprint - One of the smallest undermount footprints available |
| Solid, Robust Operation - Thoroughly tested to over 100,000 operations! |
| Full Selection of Supporting Products - Control rods, joiner kits, rod hangers, panel knobs, etc. |
 | Watch the video to learn more about how the BullFrog works.
|
| |  |
The BullFrog is easy to mount under your layout with just two screws and will work with all scales from Z to O. The control wire offers high torque and a long throw, making it easy to mount the control with minimal alignment problems.
Use your own control rod, or purchase the control rod kit to connect the BullFrog to your control panel using a a nylon control rod that includes a Z bend connector, and decorative knob. We also offer a number of additional accessories.
This version of the BullFrog is assembled and ready to install. The control rod (the rod that connects the BullFrog to your control panel) is sold separately.
Note: The assembled version of the BullFrog cannot be used with the TadPole remote control rod mount. You need to order the un-assembled version of the BullFrog if you need to use the TadPole.
To save even more money, check out our
un-assembled version priced at just $6.00!
