Each dual actuator kit includes:

• 1 - Double ended Z Bend Connector
• 2 - 18 " lengths of Control Rod (both outer and inner rods)
• 2 - Control Rod Retainer Clips
• 2 - Plain Knob kits
• 2 - TadPole remote mounts
• 1 - Installation wrench (To screw the control rod onto the Z bend connector)

Installing the dual actuator kit is a simple matter of installing the double ended Z Bend connector into the BullFrog, mounting the TadPoles on opposite sides of the BullFrog, inserting the outer control rods (red) into the TadPole mounts, and screwing the inner control rods (yellow) into the Z Bend connector.

The TadPoles comes un-assembled, but can be put together with white glue in about 5 minutes.

The control rods are mounted to the back of your control panel with a mounting clip.The knob is then screwed into the end of the yellow control rod. The knob comes unassembled, but can be put together in a few minutes with a bit of white glue. We also offer a complete selection of deluxe knobs that can be customized with your own labeling.

---

Download the complete assembly and installation guide for the BullFrog and BullFrog Accessories.

This is the first and last videos in our Using Fast Tracks Assembly Fixtures video series. To watch the complete series of videos, visit our video library.

BullFrog Dual Actuator

The BullFrog Switch Machine

Having trouble playing the videos? If the video starts and stops a lot, try pausing the video for a minute or two by clicking the pause button and then starting it again. This will buffer the video to your computer for smoother playback. If the video will not play at all, be sure you have the latest Flash player from Adobe.